Product introduction
This series of products is mainly used for the reclamation of old sand of resin sand and sodium silicate sand. It integrates multiple functions such as crushing, removing film, screening and dust removal. It has a compact structure and a small footprint. The machine is powered by a vibrating motor and works mainly with rubbing. The sand crushing rate is low, the recovery rate is high, and the shape is more round.
Working principle
Two vibration motors installed at the lower part of the cylinder are used as the power source. The vibration motor is at an angle of 45 ° to the axis of the cylinder, and the axes of the two vibration motors cross each other. After the vibration motor is started, the cylinder vibrates in the vertical direction and makes torsional vibration around its axis. The combination of these two vibrations causes the material in the cylinder to move in a vortex state. When the regenerator works, due to the vibration of the cylinder and the sand falling frame, the sand falling work is completed. The sand smaller than the hole of the falling sand grid bed falls on the screen below, and the sand clumps remain on the grid bed to be further broken. The materials on the sieve grid make vortex throwing motion, and the collision and friction between each other causes the sand particles to remove the resin film, and also makes the small sand particles continue to be broken. The sand particles smaller than the sieve grid continue to perform vortex motion on the chassis, further peel off the film, then enter the spiral groove to spiral upward, and finally discharge from the sand exit groove. Open the discharge door regularly to discharge debris.